This quick, inexpensive repair moknt not noticeable unless you are specifically looking at the drawer construction and the strength is adequate for this application. Accuride International Hettich Two-Way Travel Drawer Slides. Because there is less of a mechanical connection, the glue will serve a more vital role in the joint. Brads through bottom. Forgot password?

Knape and Vogt US Futaba Sugatsune Accuride International Fulterer USA Inc. Grass America Inc. Hafele America Co. Rev-A-Shelf 3. Woodfold - Marco Mfg Inc 1. Mechanical opening system 2. USA Bottom Center 9. Euro Side Undermount Waste not, want not. I was able to re-use the back panels for my drawers by simply cutting off the protruding rabbet on each end and the dado on the bottom.

I applied a liberal application of glue to all mating surfaces. Because there is less of a mechanical connection, the glue will serve a more vital role in the joint. I made sure to coat all contact surfaces well. Shoot brads through sides into back. Using 18 ga. I was extra careful to orient the nail gun in such a way that the nails were not likely to blow through the sides of the back panel. With an 18 ga. Brads through bottom. Shoot brads every few inches through the bottom panel into the back.

Drawer now fits perfectly. Is it strong enough? While the drawer is not quite as strong as before, the important question is whether the drawer is strong enough for the application at hand.

I contend that this drawer is still far more durable than the majority of store-bought furniture. The joints that I modified will never fail under 28 Inch Bottom Mount Drawer Slides Quick normal use in my media cabinet. And yes, it will still withstand a size XL stress test.

This quick, inexpensive repair is not noticeable unless you are specifically looking at the drawer construction and the strength is adequate for this application. Click here to cancel reply. I admit that I will sometimes spend more time fixing something than it would take to just start again from scratch, but there is a certain satisfaction and thriftiness from a materials standpoint from repairing goofs.

Or am I missing something. Hi John, Good question.

Half Lap Joint Jig For Router Nova G3 Lathe Chuck Up Vintage Marking Knife 60