All four ‘burnishers’ worked just fine. In a matter of seconds I consolidated the steel and turned four new and keen edges. I used my own home made burnisher made from some O1, 3/8″ steel round, a manufactured burnisher, a nail punch and bevel-edged chisel.  All I can hear from them is if you don’t spend big bucks for your tools, you can’t work wood. I read a long time ago that a Philips screwdriver shafts works great as a burnisher. Keep up the good work Paul. Scraper sharpening, of all the woodturning tools, is probably the easiest tool to sharpen. But there are a few details to be aware of during the sharpening process. How do I sharpen a scraper woodturning tool?  Presenting a scraper angle, this extreme into turning wood fibers will not do much besides scratch the surface. Within only a few moments, the skinny tip would be dull and curl under. Ideal Scraper Bevel Angle.  The real answer to the scraper bevel angle is to try an angle that works for you and stick with that angle. And keep this in mind, when you see a video or watch a demo, and the presenter says your scraper bevel angle must be X degrees. Just smile and know that your angle works just fine, even if it is different than their angle. What Is Cutting?. The same technique works for scrapers. Once honed, the scraper is ready for fine work such as finishing, marquetry or final levelling of wood bandings and inlays. For heavier work such as glue removal or smoothing grain prior to finishing, you will want to burnish a hook onto the scraper’s edge. The amount of hook depends on the job at hand.  Burnishing the scraper The hook that you burnish on a scraper forms the tool’s cutting edge. To create the hook you need a burnishing tool, which is a rod of steel or carbide harder than the steel used to make the scraper. It spreads the edge of the scraper slightly then rolls that edge over into a hook, creating the edge. Burnishers are quite inexpensive.
A properly burnished card scraper can remove fine shavings from even the hardest wood, offering the quality of a planed finish. Scrapers have earned their place among the shop's most indispensable tools so get the right burnisher for the job and max out your scraper's potential. A good burnisher needs to be much harder than the tool it is burnishing and highly polished with a completely smooth surface. Feb 08,  · People often ask me to recommend a burnisher they can buy for forming the turned edge to a scraper. When I suggest just using the back of a chisel or a nail set they seem either unbelieving on the one hand or disappointed on the other. Most often they want a brand, a one-size-fits all. Using a burnishing tool made of very hard high carbon steel, a 'Burr' is created along the edges of the scraper as shown at left. This is done by pushing the burnishing tool very firmly onto the scraper, and pushing it along the edge of the scraper. This causes the corners of the scraper to deform and form a sort of hook shaped burr.

Diy Wood Burning Hot Tub 4 Dust Collection Hose Harbor Freight