Aug 31,  · To drill into 2X4's you will need to set your jig up for 1 1/2" settings. This is because a 2X4 is actually 1 1/2" X 3 1/2". Once your holes are drilled you will need to use 2 1/2" screws to fasten your joint together. Place the step bit in the setup gauge on the jig base, aligning the step shoulder with the dimension mark that matches the thickness of your workpiece. Slide the stop collar onto the end of the bit and position it against the end of the stop-collar recess. Tighten the stop-collar set screw with the hex wrench. 3. Nov 05,  · Clamp the wood into the jig. Place one end of the wooden board vertically against the clamp backing on the opposite side of the jig, then pull the lever to press the clamp tight against it. Test the board to make sure that it doesn’t slide around. The clamp lever should lock into position once the clamp is fully - : 58K.
Place the step bit in the setup gauge on the jig base, aligning the step shoulder with the dimension mark that matches the thickness of your workpiece. Slide the stop collar onto the end of the bit and position it against the end of the stop-collar recess. Tighten the stop-collar set screw with the hex wrench. 3. Nov 05,  · Clamp the wood into the jig. Place one end of the wooden board vertically against the clamp backing on the opposite side of the jig, then pull the lever to press the clamp tight against it. Test the board to make sure that it doesn’t slide around. The clamp lever should lock into position once the clamp is fully - : 58K. The Kreg Pocket-Hole Jig HD is optimized for working with 2x4s and 1 1/2" thick and larger stock. It utilizes #14 heavy-duty, hardened-steel screws that provide incredible shear-resistance, as well as three anti-corrosion layers for incredible long-term moisture resistance. Works As a Stand-Alone Jig.

Things To Build Out Of Wooden Pallets Quiz Fine Woodworking Nail Gun Yu Miter Spring Clamps Home Depot 75