BOX JOINT JIG FOR ROUTER TABLE : 10 Steps - Instructables
Now to test the jig. I cut two pieces of wood the same size. The first I held up to the permanent key, turned on the router, slid the fence and cut a notch (A TONGUE). The second I added the spacer and cut a notch in the very end of the board (A GROVE). Then I removed the spacer and staggered and aligned the two notches on and up to the fixed key. Jan 20,  · This jig keeps your router bit at a consistent height, removing high spots on a board’s face. Pieces of scrap plywood and framing timber can be used to make the housing of this jig. A handful of fasteners helps with assembly, and adding some wax or finish will improve the look of the jig (and distinguish it from other scrap wood). Jan 27,  · Modern housing joints are nearly always cut with a router and a jig, but were carefully cut by Router Joint Jig 80 hand in the days before power tools. If the cut is made all the way through from the front to the back of the supporting sides, the joint is called a "through" housing joint, and no cut .

Pumpkin Carving Kit Publix 82 Bathroom Cabinet Hinge 90 Open Hardware Fast High Resolution Laser Zone Wood Frame House Projects