Mar 31,  · Leah demonstrates how to set the blade on both a No. 4 Stanley smoothing plane and a Stanley low-angle block plane. She also goes over other plane - To make the first adjustment, turn the plane upside down with the bottom about eye level. Turn the brass knurled nut until the plane iron appears just beyond the bottom of the plane. Then, with the lateral adjustment lever, move the blade to one side or the other until it is parallel to the bottom. Jul 20,  · 4) I make sure the face of the frog is periodically surface-smeared with same. This eases the swivel action when the blade edge is aligned via the lateral adjustment lever. 5) I make sure that the frog aligns level with the fore-edge of the rear aspect of the sole. This is a good position for general work which is almost all work.
May 26,  · And that’s the job of the jointer. All the smoothing plane does is make the surface look and feel smooth. Once it looks and feels good, the smoothing plane’s work is done. I find I get there faster with a No. 3. From left, smoothing planes Nos. 2, 3, and 4 Bevel-down smoothing planes. No. 1. Sole, /2 in. long; iron, /4 in. wide. Tuning a Hand Plane: The No.5 'Jack' hand plane can be used for a number of tasks (scrubbing, dimensioning, shooting, and smoothing, to name four) but to perform really well at all of these, most planes will need a little tuning. Here I've tuned two jacks to add to my o. Mar 31,  · Leah demonstrates how to set the blade on both a No. 4 Stanley smoothing plane and a Stanley low-angle block plane. She also goes over other plane -

Mitre Saw And Table 40 Turned Coffee Table Legs Canada Equipment Carbide Woodturning Tools Canada Mp3